Arduino Wiznet Ethernet
Ethernet Shield With Wiznet W5100 Ethernet Chip
TF card up to 16GB
standard Arduino Ethernet drivers
The Arduino Wiznet Ethernet W5100 Shield allows
an Arduino board to connect to the int...
The GPRS Shield is based on SIM900 module from SIMCOM and compatible with Arduino and its clones. The GPRS Shield provides you a way to communicate using the GSM cell phone network. The shield allows you to achieve SMS, MMS, GPRS and Audio via UART by sending AT commands (GSM 07.07 ,07.05 and SIM...
The module is a Micro
SD card read and write module; SCM system can read and write file on micro
SD card through SPI interface; Can initialize, read and write card by
using SD card library of Arduino IDE; A product for Arduino that
works with official Arduino boards <...
The Arduino USB Host Shield allows you to connect a USB device to your Arduino board. The Arduino USB Host Shield is based on the MAX3421E (datasheet), which is a USB peripheral/host controller containing the digital logic and analog circuitry necessary to implement a full-speed USB peripheral or...
The CC3000 Shield has a standard
Arduino shield layout with
2 rows of pins on either side. The right-side headers have been broken out on
the shield if you want to solder headers or wires for easy prototyping.
On the top-left, there is a microSD card which will work with Arduin...
shield contains two L293D motor drivers and one 74HC595 shift
register. The shift register expands 3 pins of the Arduino to 8 pins to control
the direction for the motor drivers. The output enable of the L293D is
directly connected to PWM outputs of the Arduino.